Choose Best APCBK350 – Apc BACK-UPS CS 350
Protect Your Equipment With Proper Surge Protection If your business is best, you need to connect more things than the plugs to install. And the things you need to feed are in all likelihood expensive and hard to replace. Therefore, you will need to add more power outlets, of course, and you should do this to protect your critical equipment.recommend APCBK350 – Apc BACK-UPS CS 350
Surge protectors protect your equipment by dissipating excess energy from equipment and devices connected to the surge-protector. Surge protectors are a special type of power strip that provides the added benefit of over-voltage protection. In other words, all surge arresters are power strips, but not all arrays are surge-protectors. You should not assume that a dynamometer provides surge protection. Overvoltage protection has a joule rate that indicates how much energy the tape can absorb before it needs to be replaced. Bands with the highest number of joules have a longer life.
How many joules do you need for good overvoltage protection?
You want to protect your equipment, but you do not always want to buy a new surge-protector if you protect it.
If you use one that has a very good joule, it should take many breakouts and pimples.
I suggest a rating of over 3000 joules. A little less and your surge-protector can not survive a peak. Your device may not be protected if you receive more than one high voltage notice before replacing the surge-protector.
Overvoltage protection with a low Joule value can be destroyed by a single high voltage spike. These cheap protectors must be replaced frequently. You end up saving more money in the long run by getting a good Joules surge-protector to get you started.
Surge Protector vs. Power Strip
At first glance, surge protectors and electric bands seem to do the same. But while the power strips are essentially multiple output extensions, surge-protectors are designed to protect electronic devices against (as you suspect) electrical surges (and spikes).
The most common overvoltage events occur when energy demand changes, especially if the building has old or faulty electrical wiring. Did you notice that the lights flash or dim every time you turn on the refrigerator, air conditioner, hair dryer, or other high-performance device? This sudden energy demand can lead to a short-term increase in the demanding circuit and affect all connected sockets. In North America, any amount above the standard voltage of 120V is considered excess. Small waves can occur at any time without signal and still exceed the normal operating voltage of a product.APCBK350 Apc BACK UPS CS 350 You can check price APCBK350 – Apc BACK-UPS CS 350